Installation method of liquid ring vacuum pump pipeline

Installation method of liquid ring vacuum pump pipeline

1. The exhaust pipe of liquid ring vacuum pump or compressor is connected with the intake pipe of gas-water separator. When used as compressor, the exhaust pipe of gas-water separator is connected with the system using compressed gas. Generally, the pipeline shall not be too long and the turning shall not be too fast. When it is used as a vacuum pump, the gas is discharged to the atmosphere from the air outlet of the gas water separator. In order to improve the working environment, the gas can be discharged to the outside of the working place through the pipeline. Installation method of liquid ring vacuum pump pipeline

2. Gasket shall be used to make the flange connection of liquid ring vacuum pump reliable. Especially, if the air inlet of the pump is slightly not tight, it cannot reach the predetermined vacuum degree.

3. The intake pipe of liquid ring vacuum pump or compressor shall be equipped with warehouse valve, so as to shut down the pump or compressor first when stopping, so as to prevent the water in the vacuum pump or compressor from returning to the system under the pressure of the exhaust pipe. In order to facilitate the work, it is better to install a vacuum gauge between the air inlet and the valve, so as to check whether the vacuum work normally at any time. When the water ring vacuum pump is used as a compressor, a gate valve shall be installed on the exhaust pipe of the gas-water separator, and a pressure gauge shall be installed between the exhaust pipe and the valve, so as to check whether the pressure of the compressed gas water ring vacuum pump reaches the required pressure at any time.

Dry Type Oilless Vacuum Pumps

Liquid Ring Vacuum compressor

Water ring vacuum pump