2020年9月11日星期五

Installation of water ring vacuum pump

The premise of vacuum pump operation is correct installation. If it is not properly installed, there will be many faults that can not run. How should each part of water ring vacuum pump be installed? 


1、 Install the pump body and mechanical seal

The static ring part of the mechanical seal is installed on the pump body. When the static ring part of the mechanical seal is installed, it can be wetted with water and then evenly pressed into the pump body by hand. Pay attention not to use too much force! After assembly, check whether the static ring part of mechanical seal and pump body are assembled tightly. 



Press the pump body tightly on the motor and tighten the bolts. Pay attention not to damage the static ring part of mechanical seal. Install the washer into the motor rear cover, and then install the pump body, motor front cover, bearing, motor rotor and inner bearing cover into the motor housing, and lock the bolts. Install the motor fan, retaining ring, motor shield and screw in turn. After installation, the fan shield end of the motor of the pump shall face down and be vertical to the ground, and other parts of the pump shall be ready to be installed.

CL Sereis Cone Liquid Ring Vacuum Pump

Roots Blowers

Roots Vacuum Pump 

没有评论:

发表评论