Working principle of water ring vacuum pump unit

For the corrosion-resistant water ring vacuum pump unit, we will actually use the Roots pump as the main pump in actual use, and then, we should pay attention to the water ring pump should be formed for the previous pump series.

Corrosion-resistant water-ring vacuum pump unit selected by the water ring pump to a large extent will actually become a front-end pump, in this respect, it is actually more advantageous than other vacuum pumps, because it can not only overcome a single water-ring pump operating time limit pressure difference (unit limit pressure) In fact, it will be higher than the limit pressure of the water ring pump in fact, that is, there will be a great deal of improvement, under a certain pressure on the drawback of a relatively low pumping rate, in this respect, we will actually note that it is to a great extent directly retained the Roots pump energy of the rapid operation, there is a relatively large amount of pumping. The advantages of speed.

Next, as far as the corrosion-resistant water-ring vacuum pump unit is concerned, it can actually be adapted to remove a large number of condensable steam, especially for the gas-filled oil seal mechanical vacuum pump to remove condensable steam capacity is not enough, or the use of solvents can actually make the pump oil deterioration, thus affecting The performance will be even more obvious when the vacuum system does not allow oil contamination.

As far as the corrosion-resistant water ring vacuum pump unit is concerned, when it is equipped with explosion-proof motor and its electrical appliances, to a large extent, it will directly comply with the corresponding safety rules, but also can extract flammable and explosive gases. In view of the above reasons, its application will be very extensive.