When installing roots vacuum pump, it is recommended to install it by professionals. If it is necessary to install it by ourselves due to limited conditions, we must read the instructions carefully before installing it. Do not damage the operation of components during the installation process, which will cause problems in the use of Roots vacuum pump.
1. Roots pumps shall be installed in dry, ventilated and clean places.
2. The pump shall be installed horizontally, with a space of at least 300 mm between the pump and the wall or other objects, and the oil window of the pump shall have a space for easy observation of the oil level.
3. When connecting the power supply, attention shall be paid to the motor rotation. From the tail, the rotation of the motor shaft shall be clockwise. The specific operation steps are to connect the three-phase power supply of the motor, jog the motor start button, and check whether the rotation is correct. If the rotation is opposite, replace any two terminals of the three power terminals.
4. The pipeline between the pump and the container to be pumped shall be clean, dry and free of leakage. The diameter of the pipeline shall be no less than the air inlet of roots pump as much as possible, and the length shall be short to reduce the loss of pumping speed. The pipeline connection shall be free of leakage.
5. If the extracted gas contains dust or granular substances, a suitable air inlet filter shall be installed at the inlet of the pump to avoid the damage of Roots vacuum pump caused by dust or granular substances.
The installation of Roots vacuum pump is not only to ensure the correct installation, but also to ensure that the installation environment is clean and dry to avoid damage caused by some dust inside the pump.
Small Roots Blower For Fish Pond Culture
Pneumatic Conveying Roots Blower
Water Ring Vacuum Pump
没有评论:
发表评论