Axle-holding problem of water ring vacuum pump

The water ring vacuum pump is suitable for the use of mines with small drainage volume and high negative pressure. Many problems will occur under the condition of long-term non-rest work. Among them, the special one is the axle-holding. Here we introduce the axle-holding problem of the equipment.

1. The problem of holding axle of water ring vacuum pump is mainly based on bearing assembly. The reasons are as follows:

2. The quality of lubricating oil is also related to the occurrence of this situation. If the overall vibration of the pump is too large, it is also the cause.

3. There are differences in the quality of bearings, or wear and aging caused by long-term operation.

4. In the process of assembling, the requirements of bearing positioning and design are quite different, the positioning is inaccurate, and the selection of components is unreasonable.

Above is the reason why the water ring vacuum pump holds the axle. From this we can know that the reason is the quality difference and the wear and tear aging caused by long-term work without rest. It is very important for the equipment to stop and rest. We all need to rest, not to mention the machine. Regular rest is conducive to better operation of the equipment.

JZJ2B Roots-Liquid Ring Pump System

JZPS Roots-Liquid ring Vacuum system