The cautions in the operation of vibrating screen

In the actual production, in order to prolong the life of the vibrating screen and improve the production efficiency of the equipment, we should pay attention to the following items in operation vibrating screen:
vacuum pump,vacuum furnaces,vacuum coating machine
1. Ensure the minimum clearance between all moving parts and fixtures.

2, in front of the boot, the operator to deal with on both sides of the vibrating screen and check the oil level, oil level is too high will cause the vibrator temperature rise or operation is difficult, the oil level is too low can lead to premature bearing damage.

3. Check the fastening degree of all bolts, and re-tighten once after 8 hours of initial work. Check the tension of V belt, avoid slipping in starting or working, and make sure the V belt wheel is positive.vacuum furnaces

4. The sieve should be started with no load, and after the sieve has run smoothly, it can start feeding the material. Before stopping, the material should be stopped and the material on the screen should be stopped after cleaning.

5, the feeding chute should be as close to the feeding end, and as far as possible along the sieve full width uniform feeding, its direction and run in the same direction, screen material feeding point to sieve the biggest gap is not more than 500 mm, and the best sieving effect is obtained.

6. When the exciter is rotating in the direction of the material flow, it can increase the speed of materials and increase the production capacity, but reduce the screening efficiency. When the vibration of the exciter is turned in the direction of the flow direction, the speed of the material can be reduced and the production capacity can be reduced.500kg Vacuum Oil Quenching Gas Cooling Furnace For Anne